Connecting Plumbers, LLC, Portland, OR (Photographer: Michael Truchon) has been licensed by the state of Oregon to sell plumbers’ products. They are also certified to sell parts and do plumbing services. This company offers basic and advanced plumbing services, and special tools and accessories for pipes and fittings. If you require any service or repair, they will provide it to you with 100% satisfaction.
They offer a large selection of high quality fittings and valves and accessories, including: water control valves, kitchen sink valves, drain stoppers, soapstone sinks, floor tiles, faucets, soapstone faucets, copper valves, bath and shower valves, drain handles, drain spouts, soapstone spouts, gas meters, exhaust fans, power head controls, hot water heaters and many more. Some of their plumbing fixtures are: kitchen sink valves, bathroom sink valves, sink and shower controls, water softener valves, garbage disposals, toilets and lavatory valves, laundry, drain, floor, wall and ceiling valves, and water softener taps and pipes. Connecting Plumbers also sells: pipe and tubing, water softeners, copper pipes, copper and pvc pipes, and thermoplastic pipes. Here’s more regarding look what i found visit the internet site. They also sell construction supplies like: building paper, cement, lumber, drywall, nails, hammers, electric supplies, gas, water, fire and safety supplies, auto parts, RCBS, and garage door openers. For home owners, plumbers install sewer and water lines, clean grease, correct drainage problems, install and repair sump pumps and deluxe water heater units.
Connect Plumbing is a member of the American Plumbing Company and is located at 860 SE Ridgeline Dr., Suite #B2. They accept most major credit cards and do not accept electronic checks. They provide a lifetime warranty on all pipes and tubes and guarantee that workmanship and materials will never be lacking. In addition to providing quality pipe and tubing, Connect Plumbing repairs all works under the supervision of certified plumbing contractors and is very much concerned about environment protection. The company has been involved in the green movement since 1994 and all their green plumbing products are made with recyclable materials.
The two main categories of Connect plumbing are quick connect fittings and push to connect fittings. The quick connect fittings are very much easy to install and come in a variety of sizes and configurations. All materials for these fittings are recycled and as a part of the recycling process, they are re-used to make other plumbing devices. A typical quick connect fixture consists of: two PVC pipes, a cross connection tee, a pre-tubing joint, and a water seal ring. Push connect fixtures consist of: one PVC pipe, a pre-tubing joint, and a cross connection tee.
There are many advantages of using these fittings over other types. Some of the advantages include: relatively low cost for construction purposes, fast installation time, no maintenance, no health hazard, and no connection problems. The disadvantages of using push connect stop valves include: requires frequent connections, requires large investments, requires specialized skill for installation, and requires expert knowledge to install. When you decide to use this plumbing system, it is important that you get the right fittings. If you don’t want to take any risk, get yourself a good quality set of fittings like these.
When you are plumbing your drainage system, it is advisable to use only high quality fittings. The reason is that if the hose carrying the water is not of good quality, chances are high that it would break or leak and cause the entire plumbing system to leak. Therefore, always buy high quality fittings. Your life will never be the same again!